As long as the air suspension blower is used, it will wear out. It is necessary to carry out maintenance to reduce some avoidable problems. Today, I will take you to learn the correct method of air suspension blower maintenance. I hope it will be helpful to everyone.

When the motor is running normally, slowly open the regulating valve until it exceeds the required working attitude. In addition, check whether the current of the motor does not exceed the control value, and the oil supply is interrupted, which is likely to cause an accident. Is the system software working normally? During the entire operation of the generator set, it is necessary to check whether the connecting parts are tightened, whether the vibration of the generator set and rolling bearing exceeds the standard, whether the noise of the generator set is normal, whether the rolling bearing temperature is stable, and whether the motor temperature, vibration and vibration Is the noise abnormal? If necessary, the air suspension blower should be turned off for maintenance until it is repaired.

Air suspension centrifugal blowers are prohibited from working under surge. It is concluded that all equipment oscillates regularly once every second, and it has a strong strike force. When surge occurs, the inlet and outlet valves should be adjusted quickly to facilitate the equipment to quickly escape from the surge area. When the inlet and outlet valves are opened to the highest value, surge still exists.

Many customers find that the equipment has a little fault when using air suspension blowers, but they do not care about all the normal operation of the equipment. In fact, for air suspension centrifugal blower equipment, all minor common faults and abnormalities should be paid attention to. If it is not handled properly, it is likely to cause the normal operation of all machinery and equipment.

One situation is caused by air suspension bearings. Including high temperature, turn cover, distortion, deviation of viewing angle, etc., may cause the bearing to appear abnormal. Therefore, once a similar situation is found, the best way is to use a spherical roller bearing with automatic centering adjustment to prevent problems.